|
Wheel Blast Peeners TWO ( 2 ) Wheel Wheelabrator ( BCP ) Peener
|
Air Blast Peeners SIX ( 6 ) Reciprocating Nozzle Peener
|
 |
 |
|
12-12” diameter satellite tables made of D-2 tool steel Two hip mounted 15” dia. Direct drive wheels powered by 30 HP 3600rpm motors Cabinet completely lined with cast chrome-moly wear plates Airwash separator Plus Sweco screen separator for enhanced shot size control Independently powered sweeps Timed abrasive controls Hi/lo shot hopper sensors for automatic shot adding Pulse type cartridge dust collector with magnehelic and photohelic gauges HEPA after filter Chrysler electrics Power: 460/3/60
|
Specs on Progressive Rotary Table Six ( 6 ) Nozzle Peener Serial 8276 - Six ( 6 ) variable speed oscillating nozzles connected to continuous duty two ( 2 ) tank pressure blast system complete with piping and hoses - Maximum work size: 26” wide x 36” high ( door opening ) - Six ( 6 ) Magna valve shot flow controllers - Complete machine calibration: April 2009 - Total hours: 1837 - Manufactured: 1999 - Table is divided into three partitions, each partition has two fixture positions, three nozzles are aimed at each fixture position. Load/unload is at front. - Air operated entrance and exit doors - Sweco vibratory classifier for shot size control - Low abrasive control and automatic replenishing - Complete cabinet unworn rubber lining - Light curtain safety at load position - Reverse pulse cartridge dust collector - Power:460/ 3/60 - Controls: Allen Bradley PLC 5/01 - Footprint: Main cabinet: 10’4” wide x 8’ deep x 10’4” high Pressure pot, cyclone and classifier tower: 6’ wide x 6’1” deep x 15’ high Dust Collector: 4’ wide x 4’ deep x 15’6” high
Prior Use: Peening GE / Pratt and Whitney turbine blades
|
 |
|
 |
|
|
Specs on Progressive Rotary Table Six ( 6 ) Nozzle Peener Serial 6928 - Six ( 6 ) variable speed oscillating nozzles connected to with piping and hoses - Maximum work size: 19” wide x 20” high ( door opening ) - Six ( 6 ) Magna valve shot flow controllers - Total hours: 7386 - Manufactured: 1986 - Table is divided into three partitions, two peen positions per 120 degree partition, load position in front - Air operated entrance and exit doors - Sweco vibratory classifier for shot size control - Low abrasive control and automatic replenishing - Complete cabinet unworn rubber lining - Light curtain safety at load position - Reverse pulse cartridge dust collector - Power:460/ 3/60 - Controls: Allen Bradley relay logic - Footprint: Main cabinet: 11’5” wide x 8’ deep x 8’ high Pressure pot, cyclone and classifier tower: 7’ wide x 6’1” deep x 15’ high Dust Collector: 5’5” wide x 3’6”’ deep x 13’6” high
Prior Use: Peening GE / Pratt and Whitney turbine blades |